Needle nose pliers
Italian Marble Tile
4 - Bolts
4 - Washers
4 - Nuts
Turn your rack on its side, with the legs out.
Place a washer on a bolt and slide it into the the fourth square down from the top. Do the same on the other side.
Take your other two bolts with washers, and put them in the square five up from the bottom, on both sides.
Now slide your tile, slick side up, onto the bolts.
From the under side of the tile, put a washer and a nut on all four bolts to secure the tile.
It should like this when you’re finished.
Now turn the rig over to expose the underside.
Take your heater and peel off the backing to expose the adhesive.
Place it in the center of the tile’s underside.
Now turn it over. It should look like it does here. Next, place it in your enclosure.
Now feed the wires through the heater hole in the enclosure so we can wire it up!